How To Correctly Lay Ceramic Tiles - Solving Home Decoration Problems-two

Nov 29, 2025

Leave a message

Introduction

    Deeply cultivating professional knowledge in tile laying, making your decoration construction more efficient, living safer, and avoiding detours and pitfalls!
    Elaborate on the standard process and core points of tile laying, help promote efficient decoration processes, and build a solid foundation for home safety and durability!
    Systematically popularize the knowledge of correct tiling of ceramic tiles, balancing construction efficiency and safety performance, to safeguard your decoration!
    Professional disassembly of the entire process of tile laying and installation is standardized, making decoration both labor-saving and time-saving, while ensuring long-term safety and stability during use!

Science Popularization 2

 Grassroots treatment: The "foundation" of tile laying can reduce 90% of problems by doing this step well.

    Many homeowners think that grassroots treatment is not important, but in fact, this is the main reason for hollowing out and falling off! Professional tiling will do these 4 steps:

 

 

news-790-807

01.Cleaning the base layer

First, remove all dust, oil stains, and hollow layers on the ground/walls, especially when renovating old houses. Be sure to knock off old tiles or loose cement mortar layers, otherwise new tiles will fall off sooner or later. ​

02.Leveling and sloping

Use a 2-meter ruler to check the ground, and if the height difference exceeds 3mm, use cement mortar to level it; The floor of the bathroom must be sloped (with a gradient of 1% -2%) towards the direction of the floor drain, otherwise there will be water accumulation (I have seen too many bathrooms with water accumulation, and it is because the slope was not done properly). ​
news-790-807

03.Wall roughening/hanging mesh 

Smooth walls (such as cement walls and putty walls) should be roughened first (by using cement mortar to create a rough surface), while walls with high water absorption (such as aerated brick walls) should be hung with steel wire mesh to prevent ceramic tiles from falling off later on.

04.Pre wetted base layer 

One day before laying, sprinkle water on the base layer to moisten it, but there should be no visible water (like a sponge that absorbs enough water but does not drip), otherwise the base layer will grab the moisture of the tile adhesive, resulting in weak bonding. ​

The end

    Tile tiling may seem like a simple matter of "tiling", but in reality, there are too many professional tricks hidden - from the specification matching during material selection, to the detailed control of grassroots treatment, to the standardized operation of tiling technology, each step directly affects the durability and aesthetics of the home. As an experienced craftsman with 15 years of experience, I sincerely hope that this informative article can help everyone avoid the "tile pit" in decoration, avoid detours, and save money.
    Remember, good ceramic tiles require proper craftsmanship. Standardized tiling not only enhances the appearance of the tiles, but also lays a solid foundation for home safety, allowing you to live with peace of mind and use them for a long time. If there are any further questions regarding tile selection, layout design, acceptance rework, or encountering difficulties in special scenarios (such as irregular spaces or special material tile laying), please feel free to communicate at any time. Finally, I wish everyone a smooth completion of the decoration and a beautiful and durable ideal home!

Send Inquiry